User manual

Extra Rinse This appliance is designed for saving water. However, for people with

very delicate skin (allergic to detergents) it may be necessary to rinse the

laundry using an extra quantity of water.

Press simultaneously the buttons 3 and 4 for some seconds: the pilot

light 7.2 comes on. This function stays permanently on. To remove it

press the same buttons again until the pilot light 7.2 goes off.

Delay Start

The start of the programme can be delayed by 9, 6 or 3 hours by means

of this button. The relevant light illuminates.

You must select this option after you have set the programme and before

you start the programme.

Select a delayed start:

• select the programme and the required options;

• select the delay start by pressing the button 5;

• press the button 6:

– the appliance starts its hourly countdown.

– The programme will start after the selected delay has expired.

Cancelling the delayed start after having started the programme:

• set the appliance to PAUSE by pressing the button 6;

• press the button 5 once, the light relevant to the selected delay goes

off;

• press the button 6 again to start the programme.

The DELAY START cannot be selected with the drain programme.

Important! The selected delay can be changed only after selecting the

washing programme again. The door will be locked throughout the delay

time. If you need to open the door, you must set the appliance to PAUSE

(by pressing the button 6) and then wait a few minutes. After you have

closed the door, press the button 6 again.

Start/Pause Start the programme by pressing the button 6

•To start the selected programme, press the button 6, the correspond-

ing green pilot light stops flashing. The pilot light 7.1 illuminates to in-

dicate that the appliance starts operating and the door is locked. If you

have chosen a delayed start, the appliance will begin the countdown.

•To interrupt a programme which is running, press the button 6: the

corresponding green pilot light starts flashing. It is possible to change

some options of a running programme before the programme carries

them out.