User manual

9
Customer Service
If your appliance is still not working properly after
making the above checks, contact the nearest service
centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found either on the
guarantee certicate or on the rating plate located on
the external right side of the appliance.
Installation
WARNING!
Refer to Safety chapters.
Positioning
CAUTION!
If you are discarding an old appliance that
has a lock or catch on the lid, you must
ensure that it is made unusable to prevent
young children being trapped inside.
This appliance should be installed in a dry, well ven-
tilated indoor climate where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
Ambient temperature
SN +10ºC to +32ºC
N +16ºC to +32ºC
ST +16ºC to +38ºC
T +16ºC to +43ºC
Some functional problems might occur for
some types of models when operating outside
of that range. The correct operation can only
be guaranteed within the specied tempera-
turerange. If you have any doubts regarding
where to install the appliance, please turn to
the vendor, to our customer service or to the
nearest Service Centre
The appliance shall have the plug accessible
after installation.
Electrical connection
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
• The appliance must be earthed. The power sup
-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualied electrician.
• The manufacturer declines all responsibility if the
above safety precautions are not observed.
• This appliance complies with the E.E.C. Directives.
Ventilation requirements
The airow behind the appliance must be sufcient.
1. Put the freezer in horizontal position on a rm
surface. The cabinet must be on all four feet.
2. Make sure that the clearance between the appli-
ance and rear wall is 5 cm.
3. Make sure that the clearance between the appli-
ance and the sides is 5 cm.