User manual

3
• Do not use electrical appliances inside the food storage compartments
of the appliance, unless they are of the type recommended by the manufac
-
turer.
• Do not use water spray and steam to clean the appliance.
• Clean the appliance with a moist soft cloth. Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads, solvents or metal
objects.
• Do not store explosive substances such as aerosol cans with a ammable
propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarlyqualied persons in order to avoid a hazard.
Safety Instructions
Installation
WARNING!
Only a qualied person must install this ap-
pliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the
appliance.
• Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow the
oil to ow back in the compressor.
• Do not install the appliance close to radiators or
cookers, oven or hobs.
• The rear of the appliance must stand against the
wall.
• Do not install the appliance where there is direct
sunlight.
• Do not install this appliance in areas that are
too humid or too cold, such as the construction
appendices, garages or wine cellars.
• When you move the appliance, lift it by the front
edge to avoid scratching the oor.
Electrical connection
WARNING!
Risk of re and electrical shock.
• The appliance must be earthed.
• All electrical connections should be made by a
qualied electrician.
• Make sure that the electrical information on the
rating plate agrees with the power supply. If not,
contact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension
cables.
• Make sure not to cause damage to the electrical
componentThe mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains socket only
at the end of the installation. Make sure that there
is access to the mains plug after the installation.
• Do not pull the mains cable to disconnect the ap-
pliance. Always pull the mains plug.