User manual
Location
To ensure best performance, if the appliance is posi-
tioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall
unit must be at least 40 mm . Ideally, however, the ap-
pliance should not be positioned below overhanging
wall units.
The ventilation space can
be:
• directly above the ap-
pliance
• behind and above the
top cupboard.
In this case, the space
behind the top cup-
board must be at least
50 mm deep.
50mm
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Removing the transport support
Your appliance is equipped with transport support to
secure the door during transportation.
To remove them do these steps:
1. Open the door.
2. Remove the trans-
port support from
the door sides.
3. Remove the trans-
port support from
the lower hinge
(some models).
3
2
Important! Some models are fitted with a silencing pad
under the cabinet. Do not remove this pad.
Spacers
Install the spacers provided within the accessory bag
as shown in the figures.
Place the spacers on the brackets of the condenser
(the black grill) at the back of the appliance.
Levelling
When placing the appli-
ance ensure that it
stands level. If necessary
adjust the feet using the
adjustment spanner sup-
plied.
Door alignment is de-
pendent on proper level-
ling.
Door reversibility
To change the opening direction of the door, do these
steps:
• Remove the plug from the power.
• Remove the ventilation grille. Remove the filling and
install it on the opposite side of the grille.
• Lay down the appliance back side down on a wood-
en support.
10