User manual

Problem Possible cause Solution
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set
correctly.
Set a higher temperature.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover (refer
to the illustra-
tion).
3. Replace the
used lamp with a
new lamp of the same power and specifically de-
signed for household appliances (the maximum
power is shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Technical data
RJPK2434 RJPK2734
Dimension
Height 1404 mm 1590 mm
Width 545 mm 545 mm
Depth 604 mm 604 mm
Rising Time 19 h 20 h
Voltage 230 V 230 V
Frequency 50 Hz 50 Hz
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated
indoor (garage or cellar) also, but for optimum perform-
ance install this appliance at a location where the ambi-
ent temperature corresponds to the climate class indi-
cated on the rating plate of the appliance:
9