User manual

Periodic cleaning
Caution! Do not pull, move or damage
any pipes and/or cables inside the
cabinet.
Caution! Take care of not to damage the
cooling system.
Caution! When moving the cabinet, lift it
by the front edge to avoid scratching the
floor.
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with lukewarm
water and some neutral soap.
2. Regularly check the door seals and wipe clean to
ensure they are clean and free from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
compressor at the back of the appliance with a
brush.
This operation will improve the performance of the
appliance and save electricity consumption.
Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of
the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost water
drains out through a trough into a special container at
the back of the appliance, over the motor compressor,
where it evaporates.
It is important to periodically clean the defrost water
drain hole in the middle of the refrigerator compartment
channel to prevent the water overflowing and dripping
onto the food inside.
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:
1. Disconnect the appliance from electricity supply.
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the door/doors open to prevent unpleasant
smells.
Warning! If the cabinet will be kept on,
ask somebody to check it once in a while
to prevent the food inside from spoiling in
case of a power failure.
Cleaning the ventilation grille
Make sure the door is open when removing the
ventilation grille.
The ventilation grille can be removed for washing.
1. Loosen the upper edge of the grille by pulling
outward/downward.
2. Pull the grille straight out to completely remove it.
3. Vacuum clean under the cabinet.
Troubleshooting
Warning! Refer to Safety chapters.
7