User manual

Door alignment is dependent on proper levelling.
Door reversibility
Warning! Before carrying out any
operations, remove the plug from the
power socket.
1. Remove the ventilation grille. Remove the filling
and install it on the opposite side of the grille.
2. Lay down the appliance back side down on a
wooden support.
3. Unscrew the lower hinge (a1).
4. Remove the door closure device from the hinge
and move the pin to the other side. Re-screw the
door closure device provided within the accessory
bag.
5. Unscrew and move the pedal to the other side (a3).
a3
a2
a1
6. Remove the door closure device on the door (b1).
7. Unscrew and move the bracket (b2) to the other
side.
8. Re-screw the door closure device provided within
the accessory bag to the other side (b3).
b2
b1
b3
9. Remove the door.
10. Unscrew and move the pin to the other side.
11. Re-insert the door.
12. Re-screw the lower hinge.
13. Raise the appliance and install the ventilation grille.
14. Unscrew the handle. On the opposite side remove
the hole covers by driving a 3-4 mm drift or drill into
them. Install the handle.
15. Install the hole covers provided within the
accessory bag.
Warning! Reposition, level the
appliance, wait for at least four hours
and then connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket. In case you
do not want to carry out the above
mentioned operations, contact the
nearest After Sales Service Force. The
After Sales Service specialist will carry
out the reversibility of the doors at your
cost.
ENVIRONMENTAL CONCERNS
Recycle the materials with the symbol . Put the
packaging in applicable containers to recycle it. Help
protect the environment and human health and to
recycle waste of electrical and electronic appliances. Do
11