User manual

Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be guaranteed
within the specified temperature range. If
you have any doubts regarding where to
install the appliance, please turn to the
vendor, to our customer service or to the
nearest Service Centre
Location
To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 40 mm . Ideally, however, the
appliance should not be positioned below overhanging
wall units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top cupboard
must be at least 50 mm deep.
50mm
Electrical connection
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
• The appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if the
above safety precautions are not observed.
• This appliance complies with the E.E.C. Directives.
Removing the transport support
Your appliance is equipped with transport support to
secure the door during transportation.
1. Open the door.
2. Remove the transport support from the door sides.
3. Remove the transport support from the lower hinge
(some models).
3
2
Some models are fitted with a silencing
pad under the cabinet. Do not remove
this pad.
Rear spacers
Install the two spacers and the locking pins provided
within the accessory bag as shown in the figure.
Levelling
When placing the appliance ensure that it stands level.
If necessary adjust the feet using the adjustment
spanner supplied.
10