EN User Manual Refrigerator RJKL4150 RJKL4150V
Contents Safety information Safety instructions Operation Daily Use Hints and tips 2 3 4 5 6 Care and cleaning Troubleshooting Technical information Installation 6 7 9 9 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • • • • • • Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Care and cleaning Use Warning! Risk of injury, burns, electrical shock or fire. • • • • • • • • Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
A medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance. Daily Use Cleaning the interior Caution! Do not use detergents or abrasive products to prevent damage. 1. 2. Clean the inner side of the appliance and the accessories with warm water and neutral soap. Fully dry the appliance.
Hints and tips Normal operating sounds • The following sounds are normal during operation: • • • • • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. A whirring and pulsating sound from the compressor when refrigerant is pumped. A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). A faint click noise from the temperature regulator when the compressor switches on or off.
Periodic cleaning Caution! Do not pull, move or damage any pipes and/or cables inside the cabinet. Caution! Take care of not to damage the cooling system. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. 2. 3. 4. Caution! When moving the cabinet, lift it by the front edge to avoid scratching the floor. The equipment has to be cleaned regularly: 1. 2. 3. 4. Clean the inside and accessories with lukewarm water and some neutral soap.
What to do if... Problem Possible cause The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The appliance is noisy. The appliance is not supported properly. Check if the appliance stands stable.
Problem Possible cause Solution Food products placed in the appliance were too warm. Allow food products to cool to room temperature before storing. Many food products were put in at the same time. Wait some hours and then check the temperature again. The door has been opened often. Open the door only if necessary. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance.
• Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range.
9. Remove the door. 10. Unscrew and move the pin to the other side. Door alignment is dependent on proper levelling. Door reversibility Warning! Before carrying out any operations, remove the plug from the power socket. 1. 2. 3. 4. 5. Remove the ventilation grille. Remove the filling and install it on the opposite side of the grille. Lay down the appliance back side down on a wooden support. Unscrew the lower hinge (a1). Remove the door closure device from the hinge and move the pin to the other side.
not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
www.electrolux.
