User manual

What to do if…
During operation of the appliance some smaller but an-
noying trouble can often occur, which does not require
calling a technician out. In the following chart informa-
tion is given about them to avoid unnecessary charges
on service.
Important! The operation of the appliance goes with
certain sounds (compressor and circulating sound).
This not means a trouble, but a normal operation.
Important! The appliance operates discontinuously, so
the stopping of compressor does not mean being no
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
Problem Possible cause Solution
The appliance is noisy. The appliance is not supported prop-
erly.
Check if the appliance stands stable
(all feet and wheels should be on the
floor). Refer to "Levelling".
The compressor runs contin-
uously.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer
than necessary.
The food temperature is too high. Let the food temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate
of the refrigerator.
During the automatic defrosting
process, frost defrosts on the rear
plate.
This is correct.
Water flows inside the refrig-
erator.
The water outlet is clogged. Clean the water outlet.
Food prevent that water flows into
the water collector.
Make sure that food do not touch the
rear plate.
Water flows on the ground. The melting water outlet does not
flow in the evaporative tray above
the compressor.
Attach the melting water outlet to the
evaporative tray.
There is too much frost and
ice.
The door is not closed correctly. Refer to "Closing the door".
The door gasket is deformed or
dirty.
Refer to “Closing the door”.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
The temperature in the appli-
ance is too cold.
The Temperature regulator may be
set incorrectly.
Set a warmer temperature.
7