User manual

• Do not use electrical appliances inside the food storage compartments of
the appliance, unless they are of the type recommended by the
manufacturer.
• Do not use water spray and steam to clean the appliance.
• Clean the appliance with a moist soft cloth. Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads, solvents or metal
objects.
• Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• If the appliance is equipped with an Ice maker or a water dispenser, fill
them with potable water only.
• If the appliance requires a water connection, connect it to potable water
supply only.
• The inlet water pressure (minimum and maximum) must be between 1 bar
(0,1 MPa) and 10 bar (1 MPa)
Safety instructions
Installation
Warning! Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the
appliance.
• Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow the
oil to flow back in the compressor.
• Do not install the appliance close to radiators or
cookers, oven or hobs.
• The rear of the appliance must stand against the
wall.
• Do not install the appliance where there is direct
sunlight.
• Do not install this appliance in areas that are too
humid or too colds, such as the construction
appendices, garages or wine cellars.
• When you move the appliance, lift it by the front
edge to avoid scratching the floor.
Electrical connection
Warning! Risk of fire and electrical
shock.
• The appliance must be earthed.
• All electrical connections should be made by a
qualified electrician.
• Make sure that the electrical information on the
rating plate agrees with the power supply. If not
contact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension
cables.
• Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Service or an electrician
to change the electrical components.
• The mains cable must stay below the level of the
mains plug.
• Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
3