User manual

Problem Possible cause Solution
Food products are not wrapped
properly.
Wrap the food products better.
Temperature is set incorrectly. Refer to "Operation" chapter.
The compressor does not start im-
mediately after pressing the Quick-
Freeze, or after changing the tem-
perature.
This is normal, no error has oc-
curred.
The compressor starts after a period of
time.
Water flows inside the refrigerator. The water outlet is clogged. Clean the water outlet.
Food products prevent that water
flows into the water collector.
Make sure that food products do not
touch the rear plate.
Water flows on the floor. The melting water outlet is not
connected to the evaporative tray
above the compressor.
Attach the melting water outlet to the
evaporative tray.
Temperature cannot be set. The QuickFreeze or QuickChill
function is switched on.
Switch off QuickFreeze or QuickChill
manually, or wait until the function re-
sets automatically to set the tempera-
ture. Refer to "QuickFreeze or Quick-
Chill function".
Door is misaligned or interferes with
ventilation grill.
The appliance is not levelled. Refer to "Levelling".
The temperature in the appliance is
too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food products' temperature is
too high.
Let the food products temperature de-
crease to room temperature before
storage.
Many food products are stored at
the same time.
Store less food products at the same
time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened often. Open the door only if necessary.
The QuickFreeze function is
switched on.
Refer to "QuickFreeze function".
There is no cold air circulation in
the appliance.
Make sure that there is cold air circula-
tion in the appliance.
If the advice does not lead to the desired
result, call the nearest brand-mark
service.
12