User's Manual

User Manual
Rosenberger Active Das With Intelligent Antenna system
- 49 -
Table 9 Description of the monitoring information
Parameter items Description Note
Device NO. It is a site ID Enter a unique number for each site,
different site need different number.
IM2U: can be set the number from 1 to
254
NEU: same as the IM2U
IRU: will be auto set by NEU
Sub NO. Device ID Every equipment needs an ID for
identifying code.
IM2U: Default:0, cannot be set.
NEU: can be set the number from 1 to
254
IRU: will be auto set by NEU
Smsc Tel SMSC is short for Short message server
Center
enter the operator ‘s SMSC number or
NA
Receive Port Device receive port Default :4066
Device IP Device IP Default:192.168.1.100
Device network mask Device network mask Default: 255.255.255.0
Salve equipment count Indicates that master unit can connect
how many pieces slave equipment.
IM2U: normally, one IM2U can connect
4 pieces NEU.
NEU: normally,
Start sub NO. Sub equipment start number Enter a number from 1-256
Query Tel.1~5 Modem Sim Card number Enter the Modem Sim Card number
Communication Mode Remote Communication mode Select one mode for remote control
Notify Tel. Sim Card Number If want to monitor alarm all the time,
please enter a Sim Card number, the
cellphone can receive every piece
alarm and notice
Ems IP The public network IP address Enter a IP address if want to use the
GPRS mode or TCP mode
Ems port the device communication port number Enter a port number if want to use the
GPRS ,TCP or UDP mode
Access Point Name The access point name of the mobile
network operator.
Enter a APN if want to use
GPRS ,TCP or UDP mode
5.2.3 Alarm Status
Device alarm status column corresponds to the Device alarm En/Disable column, if don’t want to get an alarm,
you can set the item is disable.