Installation guide

AV7900 Installation Guide GC1018 Rev A

Page 9

The DVD restarts when the vehicle is started

When the vehicle is started, the DVD should resume from previous point. However, if the voltage falls below

10VDC during cranking, the system will restart at the beginning of the DVD.

Solution: Check if the battery is fully charged. New vehicles rarely have a fully charged battery.

Solution: Older batteries can not provide the necessary voltage during an engine cranking.

Vehicle battery may need replacement.

Solution: Extreme climate conditions (cold or hot) will reduce the efficiency of the battery. Be sure

the battery is fully charged and in good condition. Replace the battery if needed.

The System Stays On and Never Shuts Off

The System is designed to turn off when the key is turned off. If the ACC (Red) wire is connected to a

constant 12VDC (+) power point the system will system will stay on until the battery dies.

Solution: Check the ACC connection point to be sure it is switched with the key, and relocate as

needed.

No headphone audio

The Headphone audio should be preset at all times, unless the MUTE is set to on, or a DVD Setting has

been changed in the DVD Settings Menu.

Solution: Press the MUTE Button to enable the audio and turn the MUTE OFF.

Solution: Confirm the headphones have fresh batteries, are turned on, and the ON LED Indicator

is Illuminated.

Solution: Check the DVD Setting and restore them to FACTORY SETTINGS if needed (see the

Owners Manual).

Selecting FMM pre-sets

For best operation, the FMM Pre-set selection should be on a station which is not in use or has weak

broadcast in your area.

Solution: You can also check www.RosenDealerCentral.com. This site provides you with the best

stations in your local area. Select a corresponding FMM Station when available.

Reducing audio or video noise

Audio or video noise may be induced into the system from sources ranging from harness location, power

point to poor grounding.

Solution: Re-route the wire harnesses to avoid passing over other harnesses or near electrical

motors.

Solution: Try relocating the ground point to factory ground point or factory ground wire.

Solution: In some cases, inline audio filters may be required. Contact Rosen for support on

selection of a filter.

Missing Channel B Audio

System includes a monitor A and monitor B. Monitor A is channel “A” on headphones and monitor B is

channel “B” on headphones. If audio is not present, check the following.

Solution: Check A/B switch on headphones.

Solution: Check all cable connections

Solution: Please refer to “Install Set-up Menu”.

Solution: Force channel B via Installer Setup menu