Installation guide
Copyright 2011 All Rights Reserved
AV7900 Installation Guide GC1018 Rev A
Page 8
11 Installer Setup
To access install setup menu: use the remote control, press EJECT-ENTER-1-1-2-0
To change AUX 2 input labeling, highlight AUX 2 label and scroll left/right using arrows.
To select EXT FMM, highlight EXT FMM and select on.
POD ADDR is used to manually set pod address
Auto address is based on which port the pod is plugged into.
Selecting A or B allows you to manually set the pod’s address
When manually selecting POD ADDR, an OSD will appear on opposite pod displaying what pod it
will be
FAQ’s
The monitor cables get stuck in the posts
Normally the cables will slide through the posts with very little effort. However, if you encounter difficulty,
please check the following:
Solution: Ensure that there are no obstructions inside the post.
Solution: Ensure that there are no metal burs at the entrance or exit of the posts.
Solution: Ensure that there are no kinks or knots in the cables.
Solution: Use a cable pulling lubricant.
The monitor does not fit into the headrest bucket
The AV7900 unit has been designed to fit tightly into the headrest bucket. This was done to ensure a high
quality fit with no gaps.
Solution: Use a mild soap and water solution to LIGHTLY moisten the mating surface of the
headrest bucket. CAUTION! – Do not get water on or in the electronics as damage WILL result
which will not be covered by warranty.
The FMT does not transmit audio
The system is designed to use either the internal FM Transmitter or an external FM Modulator. Select the
mode in the installation set up menu.
Solution: Check the FMT configuration to be sure that FMM is set to OFF. FMT is the default.
Finding the best Power Point
Avoid connection to wires which supply the following: fan/seat/mirror motors power, excessively large sized
wires, glow plug power lines, radio power lines, defroster power lines, etc.
Solution: Open power points can be located in the fuse box, which are designed for accessory
equipment.