Installation guide

AV7900 Installation Guide GC1018 Rev A

Page 5

Wiring diagram

7 Removing the factory headrests

IMPORTANT!

Do NOT start this step until you have inspected the seats and factory headrests for any

obstructions.

You will need to remove the existing factory headrests. The following steps will guide you through this

process.

Step 1: Determine if a locking device is present on the factory headrest. Locking devices are usually

a button or small push pin located at the base of the headrest post(s).

Step 2: If a locking device is present, press and hold the lock release, and pull firmly upward on the

headrest. If no locking device is visibly present refer to the vehicle’s owners manual or the vehicle’s

manufacturer for further instructions.