Specifications

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 9 of 30
5. OSD MENU OPTIONS
The OSD contains screen settings and options in menus and informational readouts that display
over the image, as shown below. Press MENU on the remote to open the Main Menu, as shown in
Section 5.1.
Press the ▲▼ buttons to navigate within the menu pages. Press the ►◄ buttons to navigate
between the menu page, options, and values columns. The yellow highlighted area shows the
currently selected option in the menu.
Figure 3 OSD menu pages
The available menu options will vary depending on which source signal is active.
 Press MENU to choose a setting or an option.
 Select the Back option to switch menu pages.
 Press EXIT to close the OSD and save settings.
Note: The on-screen display will timeout and close automatically after no screen activity for a
preset amount of time, which is adjustable on the Technician MenuOSD Timeout option. See
Section 6.3, OSD Timeout on page 21.
5.1. Exit
Use Exit to close the OSD. When you press MENU, the OSD opens to this screen, as shown
below. Press MENU again to close the OSD from this screen.
Press the ▲▼ buttons to access the other menu pages in the OSD.
From other settings within the OSD, press EXIT on the remote control to close the OSD.
Figure 4 Opening screen for the Main Menu
Press ► to access
the menu page
options
Press ► to access
the menu option
values
Press ▼ to
access menu
pages. The
selected menu
page is
highlighted.