Specifications

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 6 of 30
1.1.1. Control Options
Although the 10.6” display does not have a built-in IR sensor, it provides 3.3V DC
@100mA output to power an external IR receiver. The IR Receiver (P/N 0500-006) and
RC5 Remote Control (P/N 0500-019) (sold separately) enables control options inputs to
adjust the on-screen display settings.
Alternatively, you can control the 10.6” display via a cabin management system using
RS-485 and/or RS-232. For a copy of the RS-232 External Controller Message Formats
(P/N 9002934) or RS485 Network Message Definitions document (P/N 9002933), please
contact Rosen Aviation Technical Support at 541.342.3802.
Note: For directions on operating the optional universal remote control, refer to the user’s
guide enclosed with the remote.
1.1.2. Display Connections
The following cable connections are available:
 Optional HD15 Male VGA connector kit (P/N 0300-055)
 Required Female 15-pin P1 connector kit (P/N 0300-053)
 Optional 90-degree connector kit (P/N 0300-058)
 Optional HD BNC Plug to BNC Jack (P/N 106221), an adapter for a standard BNC
connector running CVBS or SDI
The 10.6” display connectors exit straight down. The 90-degree connector kit
(P/N 0300-058) contains the following adapters to route the harnesses away from the
display:
Two – HD BNC Plug to BNC Jack
Two – right-angle BNC Plug to Jack
One – right-angle D-sub 15
One – right-angle HD15
2. INSTALLATION GUIDELINES
2.1. Mounting Configurations
The 10.6 display can be flush mounted to the bulkhead, or secured to a separate mounting
structure from the top and bottom, sides, or back of the unit. Installation requirements include
 minimum mounting fasteners: four 8-32 screws.
 minimum clearance: ¼” on the sides, top, and bottom; or ⅛” to the back of the unit; or
secure the display to an aluminum structure to act as a heat sink.
Consult the Outline and Installation drawing to assist with the installation process. Pay close
attention to the dimensions and fastener depths required when considering installation
requirements.
Touching the LCD with excessive force may leave pressure spots
that show in video display. Handle with care.