Specifications

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 5 of 30
1. INTRODUCTION
Rosen’s 10.6” bulkhead display (model 1060-001) brings stunning HD widescreen picture quality
into a small aircraft’s cabin interior.
Although you can use this display in standard analog systems, via Composite and/or VGA video
inputs, the 3G HD-SDI input allows you to use it in high definition systems and connect directly to
a Rosen Blu-ray player.
This manual describes how to install these all-in-one displays onto your aircraft. It contains
everything you need to know to wire the display and confirm that it is functioning correctly.
Note: Only trained and qualified personnel should perform installation and service.
The Outline & Installation drawing and the Technical Manual are available on the Rosen Aviation
website at www.rosenaviation.com.
From the Rosen Aviation home page, select the Products tab and browse by product category.
Please contact Technical Support at 541.342.3802 if you cannot find the documentation that you
need.
1.1. System Overview
The 1060-001 high-definition display enables viewers to watch digital video signals as well as
analog video signals in both high definition and standard resolutions.
Composite and SDI are the default video signals in Auto Detect mode. The Auto Detect mode
continually searches between Composite and SDI for a valid signal and then switches to that
input. In this mode, you remain connected to either input without having to set the source. If both
Composite and SDI are connected and active, then Composite is displayed by default.
Composite, SDI, Component, and RGB are all available in Standard Operation mode. RGB-1
and Component-1 share the VGA connector. Although there are four signal choices, you can
only select from three at any given time.
Figure 1 Single display installation
VGA
SDI
Composite
RosenView MX