Specifications

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 24 of 30
6.6.2. Constant Mode
Constant enables you to specify the two sources the monitor will switch between when
the constant switch goes between an open state and a ground state.
Highlight TechnicianSource ModeSource Select and then press ENTER.
Select Constant and press ENTER. Press ▼ to select Open and then press ENTER.
Select which video input will be set to open and then press ENTER.
Press ▼ to select Ground and then press ENTER.
Select which video input will be set to ground and then press ENTER.
Figure 22 Source Mode Constant options
Select Back to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
7. TECHNICAL REFERENCES AND SUPPORT
Check the Rosen Aviation website to ensure that you are working
with the most current revision of technical documentation.
Table 2 Technical references
Product
Part Number
Location
RC5 Remote Control
0500-019
Contact Rosen Sales
IR Receiver
0500-006
Contact Rosen Sales
HD15 Male VGA connector kit
0300-055
Contact Rosen Sales
Female 15-pin P1 connector kit
0300-053
Contact Rosen Sales
90-degree connector kit
0300-058
Contact Rosen Sales
HD BNC Plug to BNC Jack
106221
Contact Rosen Sales
RS-485 Network Message Definitions
9002933
Contact Rosen Technical Support
RS-232 External Controller Message
Formats
9002934
Contact Rosen Technical Support
Outline & Installation Drawing
1060-001-CD
www.rosenaviation.com