Specifications
Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 22 of 30
6.4. Network ID
Use this option to specify the IR and RS-485 network addresses to control multiple displays from
a single cabin management system or remote. For example, the monitor ID numbers on a
universal remote correspond to the Network ID.
Each display requires a unique address on the RS-485 network. Setting this address sets the
value for both interfaces.
For information about configuring RS-485 network addresses, contact Rosen Technical Support
and request the RS-485 Network Message Definitions (P/N 9002933).
From the Technician Menu, press the ▼ button to select the Network ID, and then press
ENTER to open the screen.
Use the ▲▼ buttons to select an address between 1 and 31 for the display and press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.5. Splash Screen
(Available only when Operation Mode is set to Standard) Use this option to turn a custom splash
screen on or off. The splash screen appears for approximately eight seconds when 28V power is
first applied to the display. When enabled, the Rosen Aviation splash screen appears. When
disabled, the screen remains black.
Highlight TechnicianSplash Screen and press ENTER. Use the ▲▼ buttons to set the
option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.6. Source Mode Submenu
(Available only when Operation Mode is set to Standard) This submenu enables you to set the
Source Select mode to a specific state: either Momentary switch mode (default) or Constant
switch mode.
From the Technician Menu, select Source Mode and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Note: To ensure proper operation, perform a power cycle after changing a setting.