Specifications
Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 21 of 30
6.2.3. SDI Overscan
Use SDI Overscan to enable or disable video overscan for SDI at 480i and 576i
resolutions. When enabled, the setting cuts off a small percentage (2.5% by default)
around the edges of the picture and it resizes the image to fit the full screen. When set to
disabled, a zero percent overscan is applied to all SDI resolutions. You can also
enable/disable this feature via the RS-232 and RS-485 protocols.
From the Technician Menu, press the ▼ button to select Mode MenuSDI Overscan
and then press ENTER.
Use the ▲▼ buttons to set the option to Enabled or Disabled, and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.2.4. SDI Overscan %
Use SDI Overscan % to set the amount of overscan applied to picture edges of SDI
signals at 480i and 576i resolutions. The setting percentages are 0.0%, 2.5% (default),
3.0%, 5.0%, and 10.0%. The overscanned image will automatically update when you
switch between percentage values. You do not have to cycle power for the change to
take effect. You can also change the overscan value via the RS-232 and
RS-485 protocols.
From the Technician Menu, press the ▼ button to select Mode MenuSDI Overscan %
and then press ENTER.
Use the ▲▼ buttons to set the percentage option and then press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.3. OSD Timeout
Use OSD Timeout to set the amount of time the menu screens and control bars are visible,
without making any changes, before they timeout and close automatically.
There are three increments: 6 Seconds, 15 Seconds, and 30 Seconds.
From the Technician Menu, press the ▼ button to select OSD Timeout and then press ENTER.
Use the ▲▼ buttons to select a time increment and press ENTER.
Press EXIT to exit the OSD.