Specifications
Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 19 of 30
6.1.3. 3D Comb Filter
(Composite only) When set to Enabled, the display will eliminate dot crawl and some
noise on stationary portions of the picture.
Highlight Advanced3D Comb Filter and press ENTER.
Use the ▲▼ buttons to set the option Enabled or Disabled, and then press ENTER.
Select Back to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.1.4. Composite Sig (Signal)
(Composite only) This is a read-only screen that shows the signal strength of the
currently viewed Composite source. Composite Signal strength ranges from 0 to 1.25
Vpp in 0.25V increments. It will read NA (not available) if a Composite source is not
active or the AGC (Automatic Gain Control) (below) is set to Off.
6.1.5. AGC (Automatic Gain Control)
(Composite only) This option is a signal compensation tool that will accommodate for
strong and weak Composite signals.
Highlight AdvancedAGC and press ENTER.
Use the ▲▼ buttons to set the option On or Off, and then press ENTER.
Select Back to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
6.2. Mode Menu
Use the Mode Menu options to specify the power and operation modes, and to access the SDI
Overscan settings.
From the Technician Main Menu, select Mode Menu and then press ENTER to open the
submenu, as shown below.
Figure 20 Technician Mode Menu