Specifications

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282
Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 16 of 30
5.3.4.5. RGB Phase
(RGB only) Use RGB Phase to adjust the default phase value used for RGB signals.
Each RGB video source can have different phase values, which can result in the
RGB video image appearing to jitter. RGB Phase enables you to adjust the RGB
video image to eliminate jitter.
From the Image AdjustAdvanced submenu, press the ▼ button to choose RGB
Phase and then press ENTER to open the control bar, as shown below.
Press the ► button to increase the RGB phase value until the jittering stops.
Press ENTER to set the phase value and close the control bar.
Figure 16 RGB Phase control bar
5.4. Info
Use the Information page to review operating status, view details about the display, and access
the Technician Menu.
To open the Info page, press the INFO button on the remote, or use the ▲▼ buttons from the
Main Menu and navigate to Info.
Notes:
 Press ENTER or the ► button to highlight the Back option—required to access the
Technician Menu.
 The firmware (FM) fields vary by model and are subject to change.
Figure 17 Info page
Use Info to verify video
source and resolution
settings.
Back option
active