- Audiovox Rear Observation System Installation Manual

1. Installation Instructions

(1) Mount the mirror/monitor onto the existing rearview mirror.

a) Stick two adhesive foam backings on to the back of mirror in the two

small rectangle indents.

b) Take the two seven inch belts and slide them into the slots on the top rear

of the mirror with grooved side of the belt facing down..

Figure 1

c) Take the buckles and slide them into the lower slots on the rear of the

mirror with the buckle facing down toward the seven-inch strap.

Figure 2

NOTE: The large opened rectangle on the buckle will face away from the

seven-inch strap.

d) Mount the new rearview mirror/monitor onto the existing one. Add the

rearview mirror onto the existing mirror from one side with one fixed

belt. Then fasten the other belt on the other side of the mirror. To

prevent the RVMPKG1 from falling off, tighten the belts until secure

to the factory rearview mirror on both sides.

Figure 3

e) Cut off excess part of 7-inch straps.

(2) Connect the control box monitor cable to the rearview mirror/monitor

cable. Route the monitor cable behind the headliner of the