Specifications

Rosen Aviation 19” HD Widescreen Display
Document Number: 104328
Revision: C
Date: 03/11/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 6 of 34
3. INSTALLATION GUIDELINES
3.1. Cooling and Ventilation
The 19” displays require free-air ventilation; do not block the top, bottom, or rear vent holes.
Options:
 1-inch air gap and a minimum of 2.25 square inches vent area to the cabin above and
below the display, or
 For bulkhead installations a minimum of 1700 cubic inches around the display.
For optimal performance, provide a .5-inch or greater gap between the back of the display and
the bulkhead.
3.2. Mounting Options
You can mount a 19” display from any of the four sides by removing the #10-32 screws, or use a
rear-surface mount using the threaded holes as mounting points.
 Side mount–left and right (six screws)
 Rear-surface mount (minimum of four screws)
 Top and bottom mount (eight screws)
When mounting the display from the top, bottom, or sides, use all mounting holes. For a back
mount, use a minimum of four mounting holes. The following figures show the mounting option
dimensions for this display.
For mounting, remove only the #10-32 screws; do not remove the smaller #4-40 flathead screws.
Do not exceed a .375-inch insertion depth.
(Dimensions are in inches)
Figure 1 Dimensions for the side mounting holes
IR Receiver and
Status LED