Specifications

6.5” SlimLine LCD Page 17
Troubleshooting
Red LED is on Monitor is connected to 28 volts but is
either switched off or is not receiving a
video signal (Standby mode)
An over temp or under temp occurred
(see pages 11 and 12)
Image is distorted Verify that the pinout is correct.
Use the OSD Monitor Info sub-menu to
verify that a signal is present and not too
high or low (see page 11)
Examine system for pinched or damaged
cables
Image is black
and white when
switching
between SECAM
and PAL
PROBLEM POSSIBLE SOLUTION
Technical Support
For field support or to order parts, contact Rosen Aviation
Displays at: 1-888-668-4955
or visit us at: www.rosenaviation.com
If the image is black and white when
switching from SECAM to PAL video
standard, press the Select switch