Specifications

Rosen Aviation 17” SlimLine Display with DVI Input
Document Number: 102031
Revision: B
Date: TBD
Template: 4.2-3-6-FM; Revision D; 13 March 2008 Page 5 of 18
2.1. Cooling and Ventilation
The display is cooled by the flow of air, or natural convection. Special care must be taken with
the installation to provide a proper environment for air flow.
 Display vents: The unit is designed with vent openings on the top, bottom, and rear
surfaces. The entire top vent, and either the entire bottom or entire rear vent must be
unobstructed for a minimum of one (1) inch. The vents must also be ducted to free
air.
 Ducting: The installation must provide for an inlet duct (at bottom or rear), and an
exhaust duct at the top. Each of these ducts must have a minimum of four (4) square
inches of cross-sectional area.
Note: Display backlight will shut down if internal temperature reaches 140° F.
Note: Each mounting hole includes a 10-32 screw. To install the display, remove only the
screws that will be used to install the display. Do not remove the 4-40 flathead screws.
Note: Application requires listed connector backshell (Positronic D37000GEO-1023.5) due to
space constraints and 21WA4 combo connector.
2.2. Mounting Options
This display can be mounted from any combination of two sides.
(Dimensions in inches)
Figure 1 Top view with mounting holes
Figure 2 Bottom view with mounting holes