Specifications

Rosen Aviation 17” SlimLine Display with DVI Input
Document Number: 102031
Revision: B
Date: TBD
Template: 4.2-3-6-FM; Revision D; 13 March 2008 Page 4 of 18
1. INTRODUCTION AND DISPLAY OVERVIEW
This manual describes how to install the Rosen 17” SlimLine Display with DVI Input onto your
aircraft. It contains everything you need to know to wire the display and confirm that it is
functioning correctly.
The display receives Composite, Analog RGB, and DVI video input. DVI input is shown as Digital
RGB in the on-screen display when switching between video sources.
Note: Only trained and qualified personnel should perform installation and service.
1.1. Unpacking
Parts shipped with the 17” SlimLine Display with DVI Input:
 Outline & Installation Drawing
 17” Display with DVI Input
 Main Interface Connector kit (P/N 0300-021)
 Optional equipment sold separately:
External 7-button Controller (P/N 0300-402) shipped with Remote Controller
Technical Information (P/N 100434)
DVI Connector Kit (P/N 0300-029)
For more information about Outline & Installation drawings, please
contact Rosen Aviation Customer Service at 541.342.3802.
2. INSTALLATION GUIDELINES
There are several ways to connect the 17” Display with DVI Input to an aircraft’s entertainment
system.
Use the pinout descriptions on page 2 of the Outline & Installation drawing to assist in the wiring
process. Pay close attention to the pinout information while completing wiring connections.
Note: This display is for entertainment purposes only; connect to the non-critical power bus.
Drawings are provided to assist in the installation process. Pay close attention to dimensions and
rotations when considering installation requirements.
Touching the LCD with excessive force may leave pressure spots
that show in video display. Handle with care.