Specifications

Rosen Aviation 17” SlimLine Display with DVI Input
Document Number: 102031
Revision: B
Date: TBD
Template: 4.2-3-6-FM; Revision D; 13 March 2008 Page 11 of 18
Momentary Ground — No DVI
This mode uses the Source Select discrete input to toggle between RGB and
Composite video inputs only, based on a momentary ground. This mode uses a SPST
external momentary switch between ground and the RGB/Video Select (pin 6 of the
21WA4 combo connector). Each time the switch is pressed, the display will switch back
and forth between the Analog RGB and Composite Video inputs whether a signal is
present or not. The Source button located on the front panel membrane switch and an
optional external switch controller can also be used to switch between the RGB and
Composite Video inputs.
Momentary Ground — DVI
This uses the Source Select discrete input to toggle between Analog RGB, Digital RGB
(DVI), and Composite video based on the momentary ground input. The Source button
located on the front panel membrane switch and optional external switch controller can
be used to switch between the RGB, DVI, and Composite Video inputs.
Automatic Power-Up
SW3 On: The display will come on as soon as 28-volt power is applied.
SW3 Off: The display stays off when 28-volt power is applied. The power button on
the front panel membrane switch or the optional external switch controller
must be pressed to turn on the display.
Membrane Switch Enable
. SW4 On: Front panel membrane switch is enabled.
SW4 Off: Front panel membrane switch is disabled