Specifications

Rosen Aviation Smart Remote Display System
Document Number: 106957
Revision: A
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 8 of 24
3.1.1. Bulkhead Mounting Requirements
The Smart RMEB and RDMs do not require any external forced-air cooling.
A flush mounted RDM can mount either from the back, through an interior wall, or from
the front mounting tabs. Proud-mounted RDMs must attach from the front into the
cosmetic back.
Use the technical drawings to assist in the installation process. Pay close attention to the
dimensions when considering installation requirements. Dimensions for some models
may vary, so be sure to consult the latest drawings.
Touching the LCD with excessive force may leave pressure spots
that show in video display. Handle with care.
4. ASSEMBLY INSTRUCTIONS FOR COSMETIC COMPONENTS
This section provides instructions about how to assemble the cosmetic backs and bezels. To add
a stylish, proud-mount option, mount the cosmetic back to the bulkhead, attach the RDM to the
cosmetic back, and then snap on the bezel.
Note: Protect cosmetic and sensitive components from scratches, nicks, and debris during
hardware installation.
4.1. Mounting Cosmetic Backs to a Bulkhead
The cosmetic backs use two different types of mounting brackets, depending on the size of RDM
that you install. The cosmetic backs are a universal fit—there is no top or bottom.
Technical drawings for the Remote Display System accessories are available on the separate
high-definition display product pages on the Rosen Aviation website.
 Attach the 19”, 22”, 24”, and 26” cosmetic back to the bulkhead using the four
mounting brackets and a minimum of four FHP screws (customer supplied) in the .188
mounting holes, as shown below.
Figure 3 1901-, 2201-, 2401-, and 2601-800 cosmetic back mounting tabs
Attach to
bulkhead
Attach to
RDM