Specifications

Rosen Aviation Smart Remote Display System
Document Number: 106957
Revision: A
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 5 of 24
1. INTRODUCTION
The Smart Remote Display System consists of an ultra-thin remote display module (RDM) and a
smart, high-definition remote electronics box that can run an extra peripheral SDI display to
maximize the viewing experience. The remote electronics design provides more mounting
flexibility because the video processing electronics box can be located up to 50 feet from the
displays. The high-definition display modules are available in a range of screen sizes and the
mounting options allow customers to configure a system that fits their aircraft’s cabin interior.
This manual provides general instructions about how to install all bulkhead configurations of the
Smart Remote Display System onto your aircraft. It contains everything you need to know to wire
the components and confirm that the system is functioning correctly.
1.1. System Overview
The Smart RMEB (P/N 0700-150) (P/N 441-2028-100) is designed for aircraft with a Rockwell
Collins’ Venue™ Cabin Management System and Cabin Electronics System™ (CES). Although
the Smart RMEB can operate a second 3G-SDI display using RS-232 control and SDI cable to
route the digital video sources/signals, the Rockwell Collins’ application software will select only
one display at a time—either the RDM or the SDI. The interface circuitry and wiring is identical
for all Remote Display Module (RDM) configurations; the only difference between the
configurations is the amount of power the Smart RMEB provides to the displays.
Figure 1 Smart Remote Display System functional diagram
Smart
Remote
Electronics
Monitor Box
(RMEB)
Rosen Display (RDM)
Serialized Video
Output
Power Input
28VDC only
Ethernet Interface
CES
or
Venue
CMS
SDI
Display
Display RS-232
RS-232
SDI
HDMI IN
3G-SDI IN
USB 2.0
Analog (L/R) Audio
Output
Power Output