Specifications

Rosen Aviation Smart Remote Display System
Document Number: 106957
Revision: A
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 18 of 24
7.5.2. Horizontal and Vertical Adjustments
The Horizontal/Vertical Scale and Position settings enable you to shift the picture’s
position to fill the screen. The Scale settings enable stretching/cropping an image and the
Position settings enable you to shift the image horizontally or vertically, thus minimizing
or eliminating the black bars at the edge of the picture.
Select the Advanced and then choose an adjustment option.
A control bar, similar to Figure 17, to adjust the option will appear.
The range of values for these settings is -31 to +31, with a default of 0.
Decreasing the Scale settings will reduce or crop the picture, and increasing them will
stretch it in either direction.
Decreasing the Position settings will shift the picture left/up, and increasing them will shift
it right/down.
Figure 17 Sample adjustment control bar
7.5.3. Overscan
Use Overscan to conceal any screen anomalies that may be visible from either the HDMI
or 3G-SDI input signals. When enabled, the setting cuts off a small percentage around
the edges of the image and resizes it to fit full screen. You can set the overscan value for
any source or format, but any video is scaled to 1080p.
Select Advanced Overscan and then choose a setting value.
The options are 0% (Disabled), 1.67%, 2.5%, 5%, 7%, and 10%. The default is 0%.
The overscanned image will automatically update when you switch between percentage
values. You do not have to cycle power for the change to take effect.
Figure 18 Overscan setting options
7.5.4. Factory Default
Choose this option to perform a complete factory restore. It restores the default screen
settings on all menu options to their factory settings.
Highlight Yes. The OSD will close automatically after the Smart RMEB restores the
default settings.
7.6. Exit
Use Exit to close the Maintenance OSD Menu.