Specifications

Rosen Aviation Smart Remote Display System
Document Number: 106957
Revision: A
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 12 of 24
5.2.2. Venue Mode
The Smart RMEB in the Venue mode has an IP Address of 10.240.11.xx with a netmask
of 255.240.0.0.
The last octet of the IP address (xx) is calculated on how the address bit pins 1 thru 5 are
wired on the P2 Connector.
To specify an IP address of 10.240.11.1, wire the address bit pins 1 thru 5 on the
Smart RMEB as follows.
Table 1 A Smart RMEB IP address of 10.240.11.1 for Venue mode
P2
Connector
Pin 5
P2
Connector
Pin 1
P2
Connector
Pin 2
P2
Connector
Pin 3
P2
Connector
Pin 4
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
OPEN
OPEN
OPEN
OPEN
GND
Note: In the table above, only Bit 0 is tied to ground and all other bits are OPEN. This
combination gives binary 00001, resulting in value of 1 in decimal.
Similarly, if the Smart RMEB needs an IP address of 10.240.11.2, the address bit pin 3
(Bit 1) needs to grounded and the other pins need to be left OPEN, as follows:
Table 2 A Smart RMEB IP address of 10.240.11.2 for Venue mode
P2
Connector
Pin 5
P2
Connector
Pin 1
P2
Connector
Pin 2
P2
Connector
Pin 3
P2
Connector
Pin 4
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
OPEN
OPEN
OPEN
GND
OPEN
The IP Address of the RMEB in Venue mode will range between 10.240.11.1 and
10.240.11.31, based on how you wire the address pins 1 thru 5.
Note: If all address bit pins are OPEN, the resulting IP address will be 10.240.11.0 and
this is an invalid IP address for Venue mode. All IP addresses must be between
10.240.11.1 and 10.240.11.31.
Each Smart RMEB must have a unique IP address on the network. Multiple Smart
RMEBs with same IP address are invalid.