Specifications

Rosen Aviation Smart Remote Display System
Document Number: 106957
Revision: A
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 10 of 24
4.3. Mounting a Bezel
Mount the cosmetic back and monitor before attaching the bezel. To attach a bezel to a RDM,
align the mounting bosses with the monitor standoffs and gently press on the retaining clips to
snap the bezel into place.
Bezels attach around the perimeter of the RDMs with retention fasteners. The quantity and type
of bezel fasteners varies depending on the size of the bezel and RDM. Figure 6 shows the
different assembled retention fasteners on the bezels.
Figure 6 Different bezel retention fasteners
5. SYSTEM CONNECTIONS
Figure 7 shows the Smart RMEB’s front panel connectors. The Smart RMEB outputs a serialized
video signal via an RJ-45 cable from P4 and provides conditioned power and control to the RDM
via a harness with DA15 connectors from J3.
Figure 7 Smart Remote Display System connections
Ball stud
receivers on
32”, 42”, and
55” bezel sides
Only wire
retaining clips on
19”–26” bezels
Top and
bottom
wire clips
RDM power
controls
Aircraft power
RDM video
3G-SDI
peripheral display
RS-232
3G-SDI
peripheral
display
Aircraft I/O Ethernet
streaming, USB 2.0,
audio output
3G-SDI
input
HDMI video
input