Specifications

17” Fold Down Page 7
Installation Guidelines
Open the display to its fully-open position (about 160 degrees),
and then turn it on its side (or turn it over) to press out the (2)
pine tree clips where shown below. Save the clips for
reassembly.
Leave the display opened, set the assembly on its back, and
remove the (4) 8-32 x 3/8 socket-head cap screws (4) corner
locations (see below). Save the screws for reassembly.
Note: It is EXTREMELY IMPORTANT to set the assembly on
something such that the weight rests on the frame and not on
the plastic.
clip locations