Specifications

Rosen Aviation Remote Display System
Document Number: 105134
Revision: A
Date: 08/08/11
Template: 4.2.3-6-FM; Revision A; 16 May, 2005
Page 5 of 39
1. INTRODUCTION
Rosen’s Remote Display System consists of an ultra-thin remote display monitor and a remote
electronics box. The remote electronics design provides more mounting options because the video
processing electronics box can be located up to 50 feet from the display. The high-definition
display monitors are available in a range of sizes and mounting options that allow customers to
configure a system that fits their aircraft’s cabin interior.
This manual provides general instructions about how to install all models of the Remote Display
System onto your aircraft. It contains everything you need to know to wire the components and
confirm that the system is functioning correctly.
The model numbers listed are for reference purposes only. A wider range of specialty models is
available. For more information about a remote display system, please contact Rosen Sales or
Technical Support.
Note: Only trained and qualified personnel should perform installation and service.
1.1. Remote Display Modules
The Remote Monitor Electronics Box (RMEB) will operate one Remote Display Module (RDM),
regardless of the size. Remote Display Modules are available in these sizes and configurations:
 19” monitor – available in flush, semi proud, and proud mounts
 24” monitor – available in flush, semi proud, and proud mounts
 26” monitor – available in flush and semi proud mounts
1.2. Additional System Materials
Documentation for the Rosen Remote Display System is available on the Rosen website at
www.rosenaviation.com.
 Outline & Installation Drawings for Remote Monitor Electronics Box 0700-1xx series
 Outline & Installation Drawings for each size RDM, bezel, and cosmetic back
 Technical Manual
From the Rosen Aviation home page, select the Products tab and browse by product category.
Please contact Technical Support if you cannot find the drawing you need.
1.2.1. IR Remotes
The RMEB provides 5V @100mA output to power an external IR receiver. The remote
monitors do not have a built-in IR sensor. The following options (sold separately) enable
remote inputs with the Remote Display System and adjust the on-screen display (OSD)
settings:
 External IR Receiver (P/N 0500-006)
 HD Monitors IR kit (P/N 0500-023)
 Universal color display remote control (P/N 0500-020)
Note: For directions on operating the optional universal remote control, refer to the
User’s Guide enclosed with the remote.