Specifications

Rosen Aviation Remote Display System
Document Number: 105134
Revision: A
Date: 08/08/11
Template: 4.2.3-6-FM; Revision A; 16 May, 2005
Page 30 of 39
8.5. Splash Screen
Use this option to turn a custom splash screen on or off. The splash screen appears for
approximately eight seconds when 28V power is first applied to the display.
When enabled, the Rosen Aviation splash screen appears. When disabled, the screen remains
black.
Highlight TechnicianSplash Screen and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Press EXIT to exit the OSD.
8.6. Source Mode
This submenu enables you to set the Source Select mode to a specific state: either Momentary
Switch Mode or Constant Switch Mode.
Highlight TechnicianSource Mode and press ENTER.
Use the ▲▼ buttons to set the option and then press ENTER.
Note: To ensure proper operation, perform a power cycle after changing a setting.
8.6.1. Momentary Switch Mode
Momentary enables you to specify those sources that will be On or Off. This mode also
contains an option to specify an Auto Detect source.
If the source specified in the Auto-Detect option is connected, the display will ignore all
source commands. When that source is removed, the monitor will return to normal
momentary operation.
Note: When auto-detecting a source, sources 1 & 2 are no longer selectable during
normal momentary operation.
Highlight TechnicianSource ModeMomentary and press ENTER.
Use the ▼ to select Auto Detect and press ENTER.
Select which video input will be in an auto-detected state and press ENTER.
Use the arrow buttons to turn the other video inputs On/Off and press ENTER.
Select Back to return to the Technician Menu
Press EXIT to exit the OSD.
Figure 41 Momentary Switch Mode settings
Set Auto Detect to None
Selected if Source
Select will be Constant
mode