Specifications

Rosen Aviation Remote Display System
Document Number: 105134
Revision: A
Date: 08/08/11
Template: 4.2.3-6-FM; Revision A; 16 May, 2005
Page 13 of 39
3.3. Bezels and Mounting
An optional semi-proud mount attaches a bezel to bosses around the perimeter of the RDM with
wire retaining clips. Install the clips to mounting bosses on the bezel after any custom plating
using the Bezel Retention Hardware kit (P/N 0500-021). Figure 11 shows the assembled wire
clips on the back of the model 900-style bezel. For further dimensional information, see the
Rosen assembly drawing for your specific application.
Figure 11 Wire clip mounting boss assembly on bezel
Separate installation instructions come with the hardware kit. The number of wire clips required
will vary depending on the size of the bezel and RDM.
To add a stylish, proud-mount option, attach a cosmetic back plate to the RDM chassis and then
snap on the assembled bezel. Figure 12 shows an exploded view of the proud-mount assembly.
Align the four tabs on the monitor with the four mounting brackets on the cosmetic back plate.
Secure with two 4-40 fasteners in each tab/bracket, and torque screws to 7 ± 1 in-lbs. For further
dimensional information, see the Rosen assembly drawing for your specific application.
Figure 12 RDM proud-mount bezel assembly
Mounting brackets
on the cosmetic
back plate.