Reference Manual

8
Reference Manual
00809-0100-4045, Rev AB
Hardware Installation
March 2016
Hardware Installation
2.4 Installation procedure
Figure 2-2. Installation Flowchart
2.4.1 Seal and protect threads
2.4.2 Mount device
Note
Use wrench on flats, not on housing.
Mounting orientation
The low side pressure port (atmospheric reference) on the process pressure gauge is
located in the neck of the device behind the housing. The vent path is between the housing
and sensor. (See Figure 2-3.)
Keep the vent path free of any obstruction, including but not limited to paint, dust, and
lubrication by mounting the device so the process can drain away.
OR