Product specifications

Reference Manual

00809-0200-4420, Rev HB

Section 3: Mounting and Connection

January 2015

Mounting and Connection

Figure 3-3. Installation of WL2/WN2 Option

Installation of WL3/WL4 Option (indoor to outdoor

applications)

1. Mount the antenna on a 1.5-2 inch pipe mast using the supplied mounting equipment.

2. Mount the lightning arrestor near the building egress.

3. Install the grounding lug, lock washer, and nut on top of lightning arrestor.

4. Connect the antenna to the lightning arrestor using the supplied coaxial cable ensuring

the drip loop is not closer than 1 foot (0,3 m) from the lightning arrestor.

5. Connect the lightning arrestor to the Gateway using the supplied coaxial cable.

6. Use the coaxial sealant to seal each connection between the Gateway, lightning

arrestor, cable, and antenna.

7. Ensure that the mounting mast, lightning arrestor, and Gateway are grounded

according to local/national electrical codes.

Note

Any spare lengths of coaxial cable should be placed in 12 inch (0,3 m) coils.

A. Control Building

B. Remote Antenna

C. Cable

D. Drip Loop

E. Lightning Arrestor

F. Gateway

G. Ground

H. Earth