Product specifications

16
Reference Manual
00809-0200-4420, Rev HB
Section 3: Mounting and Connection
January 2015
Mounting and Connection
3.3 Remote antenna (optional)
The remote antenna options provide flexibility for mounting the Gateway based on wireless
connectivity, lightning protection, and current work practices.
The remote mount antenna kit includes coaxial sealant for the cable connections for the
lightning arrestor and antenna.
Find a location where the remote antenna has optimal wireless performance. Ideally this will be
15-25 ft (4,6 - 7,6 m) above the ground or 6 ft (2 m) above obstructions or major infrastructure.
To install the remote antenna use one of the following procedures:
Installation of WL2/WN2 option (outdoor applications)
1. Mount the antenna on a 1.5-2 inch pipe mast using the supplied mounting equipment.
2. Connect the lightning arrestor directly to the top of the Gateway.
3. Install the grounding lug, lock washer, and nut on top of the lightning arrestor.
4. Connect the antenna to the lightning arrestor using the supplied coaxial cable ensuring
the drip loop is not closer than 1 foot (0,3 m) from the lightning arrestor.
5. Use the coaxial sealant to seal each connection between the wireless field device,
lightning arrestor, cable, and antenna.
6. Ensure the mounting mast, lightning arrestor, and Gateway are grounded according to
local/national electrical code.
Note
Any spare lengths of coaxial cable should be placed in 12 inch (0,3 m) coils.
When installing remote mount antennas for the Smart Wireless Gateway, always use
established safety procedures to avoid falling or contact with high-power electrical lines.
Install remote antenna components for the Smart Wireless Gateway in compliance with
local and national electrical codes and use best practices for lightning protection.
Before installing consult with the local area electrical inspector, electrical officer, and work
area supervisor.
The Smart Wireless Gateway remote antenna option is specifically engineered to provide
installation flexibility while optimizing wireless performance and local spectrum approvals.
To maintain wireless performance and avoid non-compliance with spectrum regulations,
do not change the length of cable or the antenna type.
If the supplied remote mount antenna kit is not installed per these instructions, Emerson
Process Management is not responsible for wireless performance or non-compliance with
spectrum regulations.