Owner's manual

5 Clear calcnlator.
6 Enter value for & and press
cosine key (COS).
z Multiply answer from step 6 by
length of drive lever (R,).
& Write answer from step 1 down
and label 2. Clear cakxlator.
2 Add answer from step 8 to value
marked 2.
@
Press square key (x3.
11. Write down answer from step .lJ
and label lo.
12 Clear calcnlator.
13
Enter distance between drive and
driven shaft (L).
14 Subtract value marked u from
step ,lJ.
15 Write down answer from step 14
and label fi.
16 Clear calculator.
11 Enter value for B1 and press sine
key (SIN).
Fire 2-8. Connecting Linkage Length
To perform the following procedure, a
calculator with basic functions, plus the
following scientific functions, is
necessary:
-Sine Function (SIN)
-Cosine Function (COS)
-Square Function (x3
-Power Function (y”)
Use the following procedure to
determine I, the length of connecting
linkage in inches:
I Clear calculator.
2 Enter value for b1 and press
cosine key (COS).
3 Multiply answer from step 2 by
length of drive lever (R,).
4 Write down answer from step 3
and label 1.
19 Multiply answer from step .lJ by
length of drive lever (RI).
19
Write down answer from step 18
and label Is.
20 Clear calculator.
21
Enter value for a and press sine
key WN.
22 Multiply answer from step 21 by
length of driven lever &).
23
Write down answer from step 22
and label 22. Clear calculator.
24 Subtract value marked 22 from
value marked j&