Owner's manual
Table Of Contents
- Foundation™ Fieldbus Blocks
- Foundation™ Fieldbus Technology and Fieldbus FunctionBlocks
- Analog Input (AI) FunctionBlock
- Analog Output (AO) Function Block
- Arithmetic Function Block
- Discrete Input (DI) Function Block
- Discrete Output (DO) Function Block
- Integrator (INT) FunctionBlock
- Input Selector (ISEL) FunctionBlock
- Proportional/Integral/Derivative (PID) Function Block
- Signal Characterizer (SGCR) Function Block
- Diagnostics (ADB) Transducer Block
- Applications
- Analog input (AI) Function Block
- Analog Output (AO) Function Block
- Arithmetic (ARTH) Function Block
- Discrete Input (DI) Function Block
- Discrete Output (DO) Function Block
- Input Selector (ISEL) Function Block
- Integrator (INT) Function Block
- Proportional/ Integral/Derivative (PID) Function Block
- Signal Characterizer (SGCR) Function Block
- Index
FOUNDATION
TM
Fieldbus Blocks Manual
3-6
Status Handling Output or readback fault detection are reflected in the status of PV,
OUT, and BKCAL_OUT. A limited SP condition is reflected in the
BKCAL_OUT status. When simulation is enabled through the
SIMULATE attribute, you can set the value and status for PV and
READBACK.
When the block is in Cas mode and the CAS_IN input goes bad, the
block sheds mode to the next permitted mode.