Instruction manual

8 Installation and Operations Manual
Figure 2. Connectivity Diagram
Installation Verification (Refer to Table 1)
Check that the Status, Link, Video, and USB LEDs on the transmitter and
receiver units are on. Verify that the USB and Video LEDs are blinking.
Verify that Windows XP, Vista, or Windows 7 operating system has
recognized the USB audio and has installed the CMEDIA audio device.
This can be confirmed by opening the “Device Manager” and expanding the
Universal Serial Bus controllers section by clicking on the + sign. The
CMEDIA device should be listed as “USB PNP Audio Device”.
USB Device Installation
Normally Windows XP, Vista, and Windows 7 operating system will
recognize a new USB device when it is connected to a USB port and
correctly install the needed software or drivers to properly access and use
the new device. If your USB device requires special software to operate,
install the software first as outlined in the manufacturers documentation,
then connect the new USB device to a USB Type A connector on the
receiver unit. Verify that the USB device is detected and installed properly.
Operating the CrystalView DVI EX
Operating your CrystalView DVI EX system is no different than being
connected directly to your computer. The only difference is the computer
you are accessing is no longer on your desk but up to 1,640 feet away.
Any installed software application can be executed; results printed and
saved.
Transmitter Receiver
Microphone Headset
USB
Device
U SB Kbd / Mouse