Instruction manual

Orion XC Installation and Operations Manual
81
2. Put the matrix into Service Mode upon request in the popup window or through Matrix > Activate
Service Mode in the menu bar.
Note: During Service Mode, all matrix functions are disabled on the I/O boards on which updates
are being performed. An OSD notice indicating that the I/O boards were placed in Service Mode is
displayed on all monitors connected to the matrix through a CON device. Additionally, the Service
Mode is indicated by a red tool icon in the lower part of the working area of the Java tool.
Figure 84. Extender Update in Expert Mode – Step 2 (from the Service Mode of the OSD)
3. Start the update by clicking the Update button in the lower part of the working area.
4. Quit Service Mode after updating by responding to the confirmation request in the popup window
or through Matrix > Deactivate Service Mode in the task area.
5. After the update, verify through the Java tool that the updates for all extenders have been installed
correctly. This is done in Administration > Update EXT Firmware from the Protocol tab of
Expert Mode.