Instruction manual

Orion XC Installation and Operations Manual
27
System Settings
Several system settings can be set up and modified on the Orion XC. The configuration of the system
settings can only be done by users with administrator rights.
System Data
The system configuration is set up here. This can be done through either the OSD or the Java Tool.
The following settings can be modified.
Field Selection Description
Device
Text Enter the device name of the matrix (default: SWITCH_01)
Name
Text
Enter the name of the configuration that is used to save the
current settings (default: Standard)
Info
Text
Additional text field to describe the configuration (default:
Factory settings)
Activated
When Sub matrix is activated through the OSD, control of the
OSD is automatically lost. Control can be recovered by re-
opening the OSD, using the keyboard command for Sub matrix
OSD: <hot key>, <s>, <o>.
Sub Matrix
Deactivated Function not active (default)
Activated
Loads the matrix with the default configuration after a restart or
when powered on.
Load Default
Deactivated
Loads the matrix with the last saved configuration after a restart
or when powered on (default)
Activated
Save the current configuration of the matrix to flash memory
every 10 minutes.
Note: During saving of the configuration, the matrix will not be
operational. Saving occurs if changes have been made to the
configuration, or switching operations have been executed since
the last save.
Auto Save
Deactivated Function not active (default)
Activated
Echo all switching commands in the matrix through the serial
interface.
Note: This function should be enabled when using a media
controller through the serial interface.
Enable COM Echo
Deactivated Function not active (default)
Activated
Echo all switching commands in the matrix through the LAN
connection.
Note: This function should be enabled when using a media
controller via LAN connection; and on the Master matrix, when
using stacking with two or more matrices.
Enable LAN Echo
Deactivated Function not active (default)
Activated
Synchronize the slave matrix according to the switch status of
the master matrix.
Synchronize
Deactivated Function not active (default)
Activated
Synchronize the matrix based on the echo of a second matrix.
Note: This is a bidirectional synchronization where both
matrices have to be configured as Synchronize with the Master
IP of the respective other matrix.
Echo Only
Deactivated Function not active (default)
Master IP Address
Numerical value
Set the network address of the master matrix (default value:
000.000.000.000)