Instruction manual

UltraLink 2 DVI Installation and Operation Manual 51
Hotkey Host Number:
This field is combined with the VNC Viewer Hot Key Sequence field in the Unit Configuration screen to switch
to the computer using the keyboard. The KVM port number of this computer is entered in the Hotkey Host
Number field. Then, when the <VNC Viewer Hot Key Sequence > + <Hotkey Host Number> keystroke
combination is pressed, the unit recognizes it as a switching command. For example, if Ctrl+Alt is VNC Viewer
Hot Key Sequence and this computer has Hotkey Host Number set to 3, then pressing Ctrl+Alt+3 in the VNC
Viewer window will switch the user to this host computer.
Power Control Sequence – Power On, Power Off, Reboot:
If the UL2-DVI serial port is connected to a Remote Power Switch, command sequences can be entered in the
Power On, Power Off and Reboot fields to cause the power switch to power on, power off or reboot this host
computer. Refer to the manual for the Remote Power Switch in use for its power control command sequences.
The UL2-DVI serial port baud rate must be set in the Serial Port Configuration Screen to the baud rate required
by the connected Remote Power Switch.
Logging and Status
The Logging and Status Screen is accessed by clicking the Logging and Status button on the UL2-DVI
Configuration Screen. The screen displays information about users who have logged in and the actions they
have performed while logged in.
Figure 63. Logging and Status Screen
The format of a log entry is <date> <time> <type of event> <username> <IP address>. If the date, time, and
time zone have been set in the Time & Date Configuration Screen, the timestamp for each entry shows the
actual date and time the event occurred. Otherwise the timestamp reflects the elapsed time since the unit was
powered on with the default date and time (Jan 1, 2000 00:00:00). The username and IP address identify the
author of the event.
Clear Log:
The Clear Log button is used to delete all entries and completely clear the log.