Instruction manual

UltraLink 2 DVI Installation and Operation Manual 49
Hosts Configuration
The Hosts Configuration Screen is accessed by clicking the Host Configuration button on the UL2-DVI
Configuration Screen. This screen is used to identify the computers on a connected KVM switch. Each entry
can have a host name and allowed user list, as well as a hot key switching sequence, and power control
commands, if required.
This screen must contain host computer information in order for the Hosts button to be displayed in the VNC
Viewer Toolbar. Power control commands must also be entered for the Power button to be shown in the VNC
Viewer Toolbar.
Figure 61. Hosts Configuration Screen
Hosts:
The Hosts field contains a list of defined host computers. Up to 128 computers can be identified. Each line
shows an entry number and a computer name. The entry number does not have to match the computer’s port
number on the switch. New host definitions are created by clicking one of the displayed entries and entering
information in the Host configuration dialog, described below.
Search:
The Search field is used to search by name for a specific entry in the hosts list.
Sort:
This field allows sorting of the list of hosts by entry number or host name.
Erase Host Configuration:
This button is used to clear all defined host names in the list.
Add entry for unrecognised host:
This checkbox controls whether the unit will automatically add an entry to the host list when a user connects to
a computer which has not been previously identified.