Instruction manual

UltraLink 2 DVI Installation and Operation Manual 43
Use NTP:
This checkbox causes the UL2-DVI to use a Network Time Protocol server to set its date and time, instead of
manually entered values. When this field is checked, the NTP Server IP address field and Set Time from NTP
Server button are enabled.
NTP Server IP Address:
If Use NTP is checked, enter the IP address of the NTP Server in this field. In order for the unit to access a
server over the network, the necessary values in the Network Configuration Screen, described below, have to
be set.
Set Time from NTP Server:
After clicking the Use NTP checkbox and setting the NTP Server IP Address, click this button to immediately
obtain the time and date from the server. If the operation is successful, the Time & Date fields are populated
with the current date and time.
Network Configuration Screen
The Network Configuration Screen is accessed by clicking the Network Configuration button on the UL2-DVI
Configuration Screen. This screen is accessed during the Initial Configuration stage of the UL2-DVI installation
process, as described in the Installation section. The network settings of the unit can be changed at any time
by modifying the information in this screen.
The UL2-DVI supports both IPv4 and IPv6 network protocols. Click on the IPv4 tab or the IPv6 tab to display
the fields for the appropriate protocol. Many of the fields are present in both tabs and have similar functionality.
In the description below, the fields that are different or have different functionality are indicated.
Figure 56. Network Configuration Screen – IPv4